单组份钢化玻璃油墨
光泽特性：1、印上就烤显平光
2、印上放置3小时再烤为干燥后为亮光
使用方式：丝印、移印。油墨与固化剂添加比例为10：1，表干15-30分钟。金属产品烘烤120-150°C，30分钟后可完全干燥。玻璃产品烘烤100-120°C，30分钟完全干燥。强化亚克力及uv表面等塑胶产品烘烤80-100°C，30分钟完全干燥。
测试：产品从烤箱拿出来完全冷却之后可进行相应测试。
1. 划百格后使用3M胶纸拉，无掉色，脱落现象。
2. 使用99%无水酒精，500g力来回摩擦1000次，无变色，脱色等现象；
3. 使用25%的盐酸，500g力来回摩擦一千次，无脱落，变色、脱色等现象；
4. 使用25%溶液，500g力来回摩擦一千次，无脱落、变了、脱色等现象；
5. 使用100°C热水浸泡三小时，拿出后用手擦，无脱落，掉色等现象。
适用范围：
各种金属制品，玻璃制品，钢化玻璃（6H以下硬度），镀膜镜片，强化亚克力，UV喷油表面等产品。
环保检测：通过欧盟ROHS检测标准，EN-71等检测标准，环保保证产品。Glos*haracteristics: 1, printing on plain grilled significantly
2, printed on the place for 3 hours and then baked for the dry light
Use: screen printing, pad printing. Ink and curing agent to add the ratio of 10:1, the table to do 15-30 minutes. Metal products bake 120-150 degrees C, 30 minutes after the c o mplete drying. Glass products bake 100-120 degrees C, 30 minute* o mpletely dry. To strengthen the surface of UV and acrylic plastic products such as baking 80-100 ~ C, 30 minutes to dry c o mpletely.
Test: the product can be taken out of the oven after the c o mplete cooling can be carried out the corresponding test.
The 1 row grid after usin*M tape pull, no fade, shedding.
2 the use of 99% anhydrous alcohol, 500g force back and forth friction 1000 times, no discoloration, discoloration and other phenomena;
3 using 25% hydrochloric acid, 500g force back and forth friction one thousand times, no shedding, discoloration, discoloration and other phenomena;
4 using 25% sodium hydroxide solution, 500g force back and forth friction one thousand times, no shedding, changed, decolorization and other phenomena;
5 the use of 100 DEG C hot water for three hours, take out after the hand rub off, discoloration and other phenomena.
Scope of application:
All kinds of metal products, glass products, tempered glass (6h following hardnes*oated lenses, strengthen acrylic, UV injecti*urface products.
Environmental testing: through the EU ROHS testing standa*, EN-71 and other testing standa*, environmental protection products.
