仕林机械(图)_全自动烫画机_烫画机

注意:所有机器必须有牢靠的保护接地线

1.插好电源，打开红色长方形电源开关，指示灯亮.

2.在空气过滤调压器的进气口接入6公斤-8公斤的气压，气缸工作，发热板即上升.

3.将数显温控器的设定温度调整好，待温度到达设定温度后，气动烫画机，红色指示灯灭掉，烫画机，此时即可开始工作.

4.将时间控制器设定至所需时间.

Note: all machines must have reliable protection grounding line

1. Connect the power supply， open the red rectangle power switch， indicator.

2. The air inlet of the air filter the regulator access 6-8 kg pressure， cylinder， hot plate that is rising.

3. Adjust the display set temperature of the thermostat is good， when the temperature reaches the set temperature， the red light is off， can start to work at this time.

4. To set the time con1troller to the required time.

技术特点                                    

加热板采用特殊精密线管技术，可有效地保障温度的均衡和稳定；

全电子数显，温度控制器，温度时间（±2℃）电子时间控制器，全自动烫画机，信号指示，使用方便；

加热板表面，喷涂“钛氟伦”防粘层、强度高、表面光滑、烫画效果好、容易清洁；

Technical characteristics

The heating plate with special precision line pipe technology， which can effectively guarantee the temperature equilibrium and stability;

All electronic digital display， temperature con1troller， temperature (plus or minus 2 ℃) electronic time con1troller， indicator， easy to use;

Surface of the heating plate，普通烫画机， spraying 'titanium fluoride Aaron' anti-sticking layer， high strength， smooth surface， pyrograph effect is good， easy to clean;